WELDING PROCEDURE QUALIFICATION AND WELDER’S QUALIFICATION

By PakTechPoint Published 2 min read

In this article
  1. WELDING PROCEDURE QUALIFICATION AND WELDER’S QUALIFICATION
  2. STEPS TO WRITE APPROVED WPS
  3. WELDERS QUALIFICATION
  4. WELDING CODES AND STANDARDS

WELDING PROCEDURE QUALIFICATION AND WELDER’S QUALIFICATION

EN-287 (A.S.M.E SECTION IX) →   Welders Qualification.

E.N- 288  →  Procedure Qualification.

A.W.S – D -1.1  →  Structural Welding of Steel.

Advertisement

A.W.S – D – 1.2  →  Structural welding of Aluminum.

  1. Welding Variables are divided into two types:
    • ESSENTIAL VARIABLE. ( Current, voltage & travel speed.)
    • NON-ESSENTIAL VARIABLE. ( Bevel angel, rootyface, rootgap.)
  • Essential Variable effect the Mechanical Properties .
  • Non-Essential Variables doesn’t effect Mechanical Properties  no re-qualification is not required if changed.
  • If Essential Variable is changed beyond specified limits, then Procedure Re-Qualification is required.
  • Welder Qualification Certificate is valid for 2 Years.
  • If welder is absent for more than 6 months then Re-Qualification of welder is required.
  • The document written berfore writing W.P.S is Premilinary W.P.S.
  • Toughness decreases with increase in heat input.
  • If hardness increases then joint is prone to hydrogen cracking.
  • Low heat input causes high hardness.
  • Poorosity is caused due to use of damped electrode.
  • Impact test isnot required for qualifying a welder.

STEPS TO WRITE APPROVED WPS

  • Preliminary welding procedure specification
  • Welder follws the PWPS & weld the joint of given sample  in presence of welding inspector & third party inspector.
  • Then the sample is tested with NDT & D.T
  • Welding inspector will write Procedure Qualification Record including details namely:
    1. As run condition
    2. NDT result
    3. DT result
    4. Qualification range
  • Then welding engineer will write an Approve WPS if all the results are satisfactory & in the range.

WELDERS QUALIFICATION

    • Welding engineer will write WPS
    • Welder follows it & makes a joint on sample given
    • Sample is subjected to NDT & DT
    • If results are satisfactory the welder is approved & certificate is issued which is valid for 2-years.

WELDING CODES AND STANDARDS

B.S.E.N – 970   →  NDT of Fusion Welds (or) Visual Inspection.

E.N – 473         →  Vision Test.

B.S.E.N – 287   →Welders Qualification.

B.S.E.N – 288    →  Procedure Qualification.

B.S – 499           →  Welding terms.

B.S.E.N – 499    →  Covered Electrodes.

B.S – 639          → Covered electrodes.

B.S.E.N – 22553 → Welding Symbols.


Discover more from PAKTECHPOINT

Subscribe to get the latest posts sent to your email.

Share this article WhatsApp LinkedIn Facebook
Advertisement

Leave a Comment