This article is about Piping Piping QC Notes of CBT Aramco related to topic of PIPE FIT-UP AND TOLERANCES Activity as per (SAES-L-350).
Piping QC Notes CBT Aramco | PIPE FIT-UP AND TOLERANCES
PIPE FIT-UP AND TOLERANCES (SAES-L-350)
- Maximum tolerance for axial dimensions, face to face, center to face and location of attachment shall be ±3 mm.
- Flattening of bends measure as the difference between the largest & the smallest outside diameter of any cross section, shall not exceed 5% of the nominal diameter of the pipe.
- Flattening of bends at weld ends shall not exceed 3% of the nominal pipe diameter.
- Lateral transition of branches and connection from the center line of the run shall not exceed ±1.5 mm.
- Rotation of flanges, measured as the offset between elevation of bolt holes on opposite sides of flange center line shall not exceed ± 2.4 mm.
- The tilt of flange measured at the periphery across any diameter shall not exceed 1.6 mm from the square position.
- Piping over 3-inch NPS and connected to machinery/equipment, flange alignment shall be within the following limits unless piping analysis per SAES-L-120 shows that loads and
moment are within the manufacturers limit for the machinery/equipment nozzles:- Vertical bolt hole offset ±2.4mm.
- Horizontal bolt hole offset ±2.4mm.
- Rotational offset ±2.4mm.
- Flange face separation, gasket thickness ±1.6mm.
- Combination of vertical, horizontal and rotational offset ±3.2mm.
- A 6mm weep hole shall be drilled for all dummy support at 6 o’clock position for all horizontal dummy supports.
Piping QC Notes & CBT Aramco | Piping Erection & Installation
Aramco QC Questions for all QC Engineers | CBT Test
For more knowledge please check Ebooksterminal.com
Following keywords for this topics are
1. Saudi Aramco Piping Qc Interview Questions.
2. Piping Qc Notes.
3. Aramco Cbt Exam Questions Piping.
4. Piping Interview Questions and Answers Pdf.
5. Saudi Aramco Qc Interview Questions.
6. Quality Inspector Interview Questions Pdf.