INSPECTION AND TESTING OF VESSEL OR COLUMN
The following items shall be inspected and recorded during and after assembly: Level of Tray Floor The level of tray floors shall be checked…
Read articlePakTechPoint
Browse 1959 free articles, standards and practical guides about PakTechPoint.
1,959 articles in this topic
Procedure of Vessel Internal Works
Ventilation System Ventilation system shall be done using fans/blowers with sufficient capacity. Vacuum mode operation shall be preferred for ventilation, where required force ventilation…
Read article
Vessel Internal Components Installation Method
Support Ring Installation and Level Reading Method Support ring installation shall be done on a level wise stage. Install the support ring precisely on the…
Read articleAdvertisement
WORK PROCEDURE FOR MODIFICATION OF BASE PLATE BOLT HOLES -MECHANICAL
WORK PROCEDURE FOR MODIFICATION OF BASE PLATE BOLT HOLES-MECHANICAL Bolt hole distance discrepancy • Bolt Holes as per coordinates actual distance and site condition…
Read article
PROCEDURE FOR CABLE TRANSIT INSTALLATION
Tools and equipment needed should be in good condition and must be checked by Instrument Supervisor prior to· use in the construction area. These…
Read article
PROCEDURE FOR CABLE GLAND AND CABLE SEALING COMPOUND INSTALLATION
Main keywords for this article are CMP Cable Gland Installation, Barrier Gland Installation Video, PX2KX Gland, Cable Gland and Cable Sealing Compound Installation, Sealing…
Read article
PROCEDURE OF FOUNDATION FIELDBUS SEGMENT CHECK
TOOLS AND EQUIPMENT USED IN FOUNDATION FIELDBUS (FF) SEGMENT CHECK Tools and equipment needed should be in good condition and must be checked by…
Read article
PROCEDURES FOR ANALYZER INSTALLATION
TOOLS AND EQUIPMENT USED FOR ANALYZER INSTALLATION Tools and equipment needed should be in good condition and must be checked by Instrument Supervisor prior…
Read article
PROCEDURE FOR INSTRUMENT CABLING WORKS
PROCEDURE FOR INSTRUMENT CABLING WORKS Pre-installation Activities Prior to cable laying/pulling, ensure that the cable trench, duct bank, raceway, cable tray and conduit…
Read articlePROCEDURE FOR INSTRUMENT BRANCH CABLE TRAY INSTALLATION
General Requirements All cable trays and supports will be installed as shown on EPC approved design construction drawings and located to avoid interferences with other…
Read article
PROCEDURE OF INSTRUMENT PIPING AND TUBING INSTALLATION
This article is related to PROCEDURE OF INSTRUMENT PIPING and TUBING INSTALLATION for Engineers and supervisor.
Read article