INSTALLATION OF SHIMMING PLATE FOR HANGING PIPE SUPPORTS
1.0 PURPOSE 2.0 SCOPE 3.0 APPLICABLE DOCUMENTS 4.0 RESPONSIBILITY 5.0 MANPOWER 6.0 TOOLS & EQUIPMENT 7.0 METHODS/PROCEDURES 8.0 QUALITY CONTROL 9.0 SAFETY PRECAUTION 10.0…
Read articlePakTechPoint
Browse 1959 free articles, standards and practical guides about PakTechPoint.
1,959 articles in this topic
RTR FLANGE TIGHTENING, BOLT TORQUING PROCEDURE | METHOD STATEMENT
1. PURPOSE. 2. SCOPE. 3. REFERENCES. 4. RESPONSIBILITIES. 5. PROCEDURE. 6. SAFETY. 7. ATTACHMENT. 1.0 PURPOSE This procedure or method statement shall provide minimum…
Read articlePipelines and Equipment Wrapping by STOPAQ Procedure | Method Statement
1. PURPOSE. 2. SCOPE. 3. REFERENCES. 4. RESPONSIBILITIES. 5. PROCEDURE. 6. SAFETY. 7. ATTACHMENT. 1.0 PURPOSE This method statement shall provide minimum Guidelines for…
Read articleAdvertisement
METHOD STATEMENT FOR PIPING SPOOL DRAWING PREPARATION AND WELD JOINT
1. GENERAL 2. DEFINITION OF SPOOL ERECTION DRAWING 3. SPOOLGEN SET-UP 4. SPOOL DRAWING PROVISION MATRIX 5. SPOOL NUMBERING METHOD 6. WELDING JOINT NUMBERING…
Read articleVALVE SEAT LEAK TEST PROCEDURE | METHOD STATEMENT
This article is about valve seat leak test procedure, Valve Backseat Test, Gas valve, Gate valve, Check valve and Ball valve Testing Procedure and…
Read articleBLASTING / PAINTING WORK PROCEDURE | METHOD STATEMENT
1. SCOPE: This Method Statement is described to carry out abrasive blasting and coating works in shop and touch-up/repair works of weld joints in…
Read articleVESSEL, DRUM, TOWER ASSEMBLEY PROCEDURE
1. Preliminary The purpose of this procedure is to describe the installation of FRP-made internals into the Washing Drum. Internals assembly shall be performed…
Read articleINSTALLATION OF VESSEL, TOWER AND DRUMS INTERNALS
1.0 PURPOSE. 2.0 SCOPE. 3.0 APPLICABLE DOCUMENTS. 4.0 RESPONSIBILITY. 5.0 MANPOWER. 6.0 TOOLS & EQUIPMENT. 7.0 METHODS/PROCEDURES. 8.0 QUALITY CONTROL. 9.0 SAFETY PRECAUTION. 10.0…
Read articleElevator Commissioning and Testing Procedure | Method Statement
1. General moving parts Test, Visual Inspection Correct lubrication of base enclosure and level doors 2. Base tower section Visual Inspection Welding line correct, formation…
Read articleCHECKLIST FOR ELEVATOR FUNCTION TEST AND LOAD TEST
1. Visual Inspection A certified Inspector shall check and verify all documents and other pertinent papers of equipment to be load tested. The structure…
Read articleVESSEL FINAL BOX-UP WORK PROCEDURE | METHOD STATEMENT
1. PURPOSE 2. SCOPE 3. APPLICABLE DOCUMENTS 4. RESPONSIBILITIES 5. MANPOWER 6. TOOLS AND EQUIPMENT 7. METHODS / PROCEDURES 8. QUALITY CONTROL 9. SAFETY…
Read articleMasterFlow 648 Installation for Bedding, Grouting & Precision Bearing
THIS METHOD STATEMENT COVERS THE PREPARATION & INSTALLATION OF MasterFlow 648 (Formerly Known As MASTERFLOW 648CP), FOR USE IN BEDDING, GROUTING & PRECISION BEARING…
Read article